inverter,plc,drive,control
FX - FX0 - FX1S -FX1N - FX2N -FX2NC - FX3G - FX3U -FX3UC -( Q plc - AlfaHMI-PANEL AC DRIVES  Plc Cable Mitsubishi PLC software
programmable logic control
Mitsubishi plc user manual / hand book
FX Series Programmable Controllers Hardware Manual  (Pdf)
MELSEC MEDOC – Start-up guide FOR DOS (Pdf)
MX CHANGE FOR MELSEC MEDOC PLUS (Pdf)
Melsec Medoc plus Beginner´s Manual  (Pdf)
FX1seriesHandyManual.pdf
WHAT-IS-SERIAL-COMMUNICATION ?
The FX-4AD-TC analog block amplifiest he signal from four thermocouple sensors (typeK or J)
and converts the data into 12 bit reading's stored in the FX base unlt. Both Centigrade ('C) and
Fahrenheit ('F) can be read. Reading resolution is 0.4'C/0.72'F of type K and 0.3"C/0.54'F of type J.
All data transfers and parameter settings are adjusted through software coonf t trhoel FX-QAD-TC,
by use of the TOlFROM applied instructions tinh e FX PC.
Note :R (pr0grammable mW1m versions 2.0 or later (thase with serial number1 3 XXXX or larger)
are required as these units have the TO/FROM applied instructions in their instructions et.
All Ffic Models may be used.
The FX-4AD-TC occupies 8 points of I/O on the FX expansion bus. The 8 points can be allocated
from either Inputs or outputs. The FX-4AD-TC draws 40mA frtohme 5V rail of the FX base unit or
powered extension unit.
Thermocouples with the following specifications can be used: TypKe (JIS 1602-1981)
Type J (JIS 1602-1 981)
** Cehcking special function block numbers
Other special units or blockuss e t hFaRt OWOc ommands, sucahs analog input blocks
analog output blocks and
high-speed counter blocksc,a n be directly connected to the base unit FX programmable
controller  to
the right sideo f other extension blockso r units. Each special bloicsk
consecutively numberedfr om 0 to 7
beginning with the one closestto the base unit.
A maximum of eight special bcloacnk sb e connected.
FX-4AD-TC Thermo-couple interface for Mitsubishi Melsec FX PLC
FX-4AD-TC user manual
The FX-4AD-TC
FX-2AD-PT  PT100 probe interface
FX-4AD-TC  Thermo-couple interface
FX-1HC  High speed counter
FX-1PG-E  Pulse output
FX-16NP/NT  Net-mini interface
FX-16NP/NT-S3  Net-mini-S3 interface
FX-4AD  Analog to digital converter
FX-2DA  Digital to analog converter
Special function block for Mitsubishi plc