FX-232AW/AWC Optional Programming Port for melsec plc

FX-232AW Optional Programming Port
This section describes connection to peripheral equipment (programming tool, data access unit
and electronic operation terminal) using the FX2N-232-BD, FX1N-232-BD, FX0N-232ADP, FX2NC-
232ADP, FX1N-422-BD, or FX2N-422-BD as well as cautions on communication. For the operating
procedure of each peripheral equipment and installation of each interface, refer to the
corresponding manual.
11.1 FX2N-422-BD, FX1N-422-BD
When an FX2N-422-BD is installed on the FX2N Series, or when an FX1N-422-BD is installed on
FX1N or FX1S Series, the following peripheral equipment (programming tool, data access unit and
electronic operation terminal) can be connected.
However, the FX2N-422-BD consumes 5V DC, 60 mA from the FX2N programmable controller,
and the FX1N-422-BD consumes 5V DC, 60 mA from the FX1S or FX1N programmable controller.
Make sure that the current consumption of 5V DC for special extensions and peripheral
equipment does not exceed the capacity of the 5V DC power of the FX2N, FX1N or FX1S.

The MITSUBISHI FX-232AW driver enables communication between the
Studio system and some of the Mitsubishi FX series devices
using the FX232AW serial interface, in accordance with the specifications covered in this document.
This document was designed to help you install, configure and execute the driver to enable communication with
Mitsubishi devices. The information in this document is organized as follows:
** Introduction: Provides an overview of the MITSUBISHI driver documentation
** General Information: Provides information needed to identify all the required components (hardware and software)
used to implement communication between Studio and the MITSUBISHI driver
** Installing the Driver: Explains how to install the MITSUBISHI driver
** Configuring the Driver: Explains how to configure the communication driver
** Executing the Driver: Explains how to execute the driver to verify that you installed and configured the driver correctly
** Troubleshooting: Lists the most common error codes for this protocol and explains how to fix these error
** Sample Application: Explains how to use a sample application to test the driver configuration
Revision History: Provides a log of all modifications made to the driver and the documentation

FX0, FX0S, FX0N, FX1S：9.6kbps
FX1N, FX1NC：19.2kbps
FX3G：115.2kbps
FX2N(Ver.3.00)，FX2NC(Ver.3.00)：9.6kbps
FX2N(Ver.3.00)，FX2NC(Ver.3.00)：19.2kbps
FX3U, FX3UC：115.2kbps
FX1,FX2(FX), FX2C：9.6kbps
FX2N-10GM, FX2N-20GM：9.6kbps
FX-10GM, FX-20GM：9.6kbps
FX2N-1RM(-E)-SET：9.6kbps