inverter,plc,drive,control
FX - FX0 - FX1S -FX1N - FX2N -FX2NC - FX3G - FX3U -FX3UC -( Q plc - AlfaHMI-PANEL AC DRIVES  Plc Cable Mitsubishi PLC software
programmable logic control
FX-16E-TB/UL 16 pt (Direct input/output) FX2NC-ooMT-D/UL
FX2NC-ooEX-D/UL
FX2NC-ooEYT-D/UL
FX-16E-TB/UL 16 pt Accessories
- Input / output extension block labels
- Terminal layout cards
FX-16E-TB/UL The connections required between the FX2C, FX2NC
main unit and a terminal block are shown in the diagram
below with an example for inputs X000 to X017 and outputs Y000 to Y017.
The I/O connector should be the 20-pin type and should conform to
MIL C 83503 of Military Standard.
Note
  Do not lay I/O cables next to power cables or allow them to share the
same trunking duct.
  Where I/O signals are used over an extended distance consideration
must be made for voltage drop and noise interference.
Use crimp-style terminals of the dimensions shown in the figure below.
  Tighten terminals at a torque of 0.5 to 0.8 N.m. Securely tighten terminals
so that malfunction does not occur.
FX-16E-TB/UL
Terminal blocks are not equipped with built-in fuses. In order to
prevent breakdown of circuits caused by
load short-circuit, provide a fuse of 5 to 10 A for every four points.
[ DC LOAD ]
Connect a noise suppression diode to a DC inductive load in parallel.
If the diode is not connected, the life time of the contact becomes
considerably shorter.
Select a noise suppression diode whose reverse withstand voltage is
5 to 10 times or more the load voltage and whose current in the forward
direction is not less than the load current.
Input terminal block
FX-16E-TB/UL,16 pointt (Direct input/output) FOR FX PLC MELSEC
FX-32E-TB/UL
FX-16EX-A1-TB/UL
FX-16E-TB/UL  FX-16E-TB/UL 16 pt (Direct input/output)
FX Series Programmable Controllers Hardware Manual  (Pdf)
MELSEC MEDOC – Start-up guide FOR DOS (Pdf)
MX CHANGE FOR MELSEC MEDOC PLUS (Pdf)
Melsec Medoc plus Beginner´s Manual  (Pdf)
FX-16E-TB/UL,16 point (Direct input) For
Mitsubishi Melsec FX PLC  user manual / hand book
FX INPUT AND OUTPUT TERMINAL BLOCKS user manual
FX-16E-TB user manual.pdf